| |
| Water Resources NSDI Node | |
|---|---|
<http://water.usgs.gov/lookup/getspatial?ofr99-198_wlc80_96>
This digital data set was created from 5,429 wells measured in both 1980 and 1996. The water-level-change contours were drawn manually on mylar. The contours were converted into a digital map at a scale of 1:1,000,000. The data should not be used at scales larger than 1:1,000,000.
The information provided in this introduction is found in U.S. Geological Survey Professional Paper 1400-B (Gutentag and others, 1984). This data set consists of digital water-level-change contours for the High Plains aquifer in the United States, 1980 to 1996. The High Plains aquifer, which underlies about 174,000 square miles in parts of eight states, is the principal water source in one of the nation's major agricultural areas. In 1980, about 170,000 wells pumped water from the aquifer to irrigate about 13 million acres.
The High Plains aquifer is a regional water-table aquifer consisting mostly of near-surface sand-and-gravel deposits. In 1980, the maximum saturated thickness of the aquifer was about 1,000 feet and averaged about 200 feet. Hydraulic conductivity and specific yield of the aquifer depend on sediment types, which vary significantly both horizontally and vertically. Hydraulic conductivity ranged from less than 25 to greater than 300 feet per day and averaged 60 feet per day. Specific yields ranged from less than 10 to 30 percent and averaged about 15 percent.
The High Plains aquifer boundaries were determined by erosional extent of associated geologic units and by hydraulic and physiographic boundaries where the High Plains aquifer extends eastward from the Great Plains physiographic province (Fenneman, 1931). In most of the area, the erosional extent of the hydraulically connected Tertiary and Quaternary deposits were used as the aquifer boundary. In eastern Nebraska, streams and physiographic boundaries were used as the aquifer boundary.
Reviews Applied to Data --
This electronic report was subjected to the same review standards that apply to all U.S. Geological Survey reports. Reviewers were asked to check the topological consistency, tolerances, attribute frequencies and statistics, projection, and geographic extent. Reviewers were given digital data sets for checking against the source maps to verify the linework and attributes. The reviewers checked the metadata files for completeness and accuracy. Related Spatial and Tabular Data Sets --
Predevelopment to 1980 water-level change digital data set 1980 to 1994 water-level change digital data set 1980 to 1995 water-level change digital data set 1980 to 1997 water-level change digital data set
References Cited --
Fenneman, N.M., 1931, Physiography of western United States (1st ed.): New York, McGraw-Hill, 534 p.
Gutentag, E.D., Heimes, F.J., Krothe, N.C., Luckey, R.R., and Weeks, J.B., 1984, Geohydrology of the High Plains aquifer in parts of Colorado, Kansas, Nebraska, New Mexico, Oklahoma, South Dakota, Texas, and Wyoming: U.S. Geological Survey Professional Paper 1400-B, 63 p.
McGuire, V.L., Stanton, C.P., and Fischer, B.C., 1999, Water-level changes in the High Plains aquifer, 1980 to 1996; U.S. Geological Survey, Mar. 1, 1999, http://ne.water.usgs.gov/html/highplains/hp98_web_report/hp98fs.htm .
Webmaster@ne20dnelnc.cr.usgs.gov
h20team@usgs.gov
Although this data set has been used by the U.S. Geological Survey, U.S. Department of the Interior, no warranty expressed or implied is made by the U.S. Geological Survey as to the accuracy of the data and related materials.
The act of distribution shall not constitute any such warranty, and no responsibility is assumed by the U.S. Geological Survey in the use of this data, software, or related materials.
http://water.usgs.gov/lookup/getspatial?ofr99-198_wlc80_96>
Webmaster@ne20dnelnc.cr.usgs
Maintainer: Water Webserver Team |  |